2017 Ford Expedition Alignment in Fort Worth, TX

An alignment is not automatically required at every tire rotation if the 2017 Ford Expedition tracks straight and the tires wear evenly. It is worth checking sooner when steering changes or a road impact may have altered the wheel angles. David McDavid Ford measures the current settings against Ford’s factory specifications before recommending an adjustment.

• Check alignment after major pothole impacts.
• Have the angles reviewed after suspension work.
• Use tire wear and steering behavior as practical warning signs.

Wheels that are out of alignment scrub the tires as the SUV rolls, which can wear one edge of the tread faster than the other. You may also notice that the steering wheel does not sit straight while driving on a flat road. A measurement at David McDavid Ford can show whether adjustment is needed.

• Vehicle pulls left or right on a flat road.
• Steering wheel sits off center while driving straight.
• One tire edge wears faster than the other.

The inspection also considers tires, steering, and suspension components that could prevent the alignment from holding. The goal is to identify the current angles first, then make the adjustment that the vehicle’s suspension permits. This approach helps separate an alignment correction from a worn-component repair.

• Camber, caster, and toe measurement on all four wheels.
• Adjustment toward the manufacturer’s specification where applicable.
• Inspection of tires, steering, and suspension wear.

An alignment cannot correct looseness or wear in a steering or suspension component. David McDavid Ford checks the relevant components and explains whether a repair is needed before proceeding. This inspection helps avoid paying for an alignment that may not remain within specification.

• Inspect tie rods for wear or looseness.
• Check ball joints and struts before setting angles.
• Review the condition that could cause alignment settings to change.

It becomes more worthwhile after symptoms, a major pothole impact, suspension work, or replacement of a steering or suspension component. A measurement can confirm whether the wheel angles remain within the manufacturer’s specification. Booking an appointment lets you learn whether an adjustment is needed before paying for one.

• Check for even tread wear across each tire.
• Pay attention to steering that is no longer centered.
• Measure alignment after an impact or suspension repair.

The service team measures all four wheel angles and inspects the tires, steering, and suspension for conditions that could affect alignment. The dealership’s Fort Worth service department handles routine maintenance and complex mechanical work using specialized Ford service knowledge and genuine Motorcraft parts. You can schedule service online.

• Address: 300 West Loop 820 South, Fort Worth, TX 76108.
• Measure camber, caster, and toe on all four wheels.
• Book online through the service scheduler.

Next, camber, caster, and toe are measured on all four wheels. The readings are compared with the manufacturer’s specification, and the adjustable angles are corrected where the suspension allows. This step addresses the wheel positions that influence straight-line tracking, steering-wheel position, and tread wear.

After adjustment, the service includes before-and-after alignment information so you can see the measured change. A road test helps confirm the vehicle’s steering response and tracking. The service department can explain whether worn steering or suspension components require attention before an alignment can hold properly.

Schedule service with David McDavid Ford by calling (817) 420-7990.

Road impacts can change wheel angles without creating an immediate warning light. A vehicle that begins pulling, develops an off-center steering wheel, or wears a tire edge unevenly should be inspected rather than driven until the problem worsens. Measuring the alignment gives a clearer answer than relying on steering feel alone.

Convenience options include Ford Mobile Service for eligible maintenance and repairs at home or work, along with Ford Pickup & Delivery for more extensive service. Customers visiting the West Loop 820 facility can also ask about available transportation and waiting-area options. Schedule an appointment online or call (817) 420-7990.

Where the suspension permits adjustment, the angles are brought back toward factory specification. The inspection also looks for tire, steering, and suspension wear that could hold an angle out of specification. This is important because an alignment setting cannot compensate for a loose or worn component.

For the 2017 Ford Expedition, accurate measurement can help address pulling, an off-center steering wheel, uneven tread wear, and vibration at speed. Before-and-after readings clarify what changed during service, while a road test helps verify the vehicle’s behavior afterward. Bring your 2017 Ford Expedition to David McDavid Ford in Fort Worth for a factory-spec alignment — schedule service.