2019 Ford Ranger Oil Filter

The published schedule for this model year calls for oil filter replacement every 10,000 miles. Replacing it with the oil gives fresh oil a clean filter rather than sending it through one already holding debris.

• The filter captures debris carried by the oil.
• A loaded filter can open its bypass valve.
• Service history helps determine when the next maintenance is due.

The filter is matched to the 2019 Ford Ranger's 2.3-liter inline-four engine. The technician renews the sealing component used by the engine and checks the filter seal after operation to help confirm the service is properly sealed.

• Filter matched to the engine's specification
• New drain plug gasket or washer where the engine uses one
• Leak inspection at the filter seal after running the engine

The engine continues receiving oil, but the oil is no longer being filtered once the bypass valve opens. That quiet change is why the filter is replaced alongside the oil instead of being stretched across two changes.

• Debris remains captured in an aging filter.
• The bypass valve may allow unfiltered oil flow.
• The manufacturer's schedule calls for replacement every 10,000 miles.

Correct fit and application matter because the filter must work with the engine's lubrication system. David McDavid Ford can match the filter to the engine actually fitted without relying on a generic substitute.

• Engine displacement: 2.3 liters
• Engine configuration: four-cylinder inline-four
• Filter selection is based on the engine application

A filter that has collected debris may eventually open its bypass valve, allowing oil to circulate unfiltered. Replacing both together keeps the fresh oil moving through a filter prepared for the next service interval.

• The filter holds debris removed from the oil.
• The bypass valve opens when the filter loads.
• Service history helps establish the vehicle's maintenance timing.

The Fort Worth service department can arrange an oil filter replacement with a filter matched to the 2019 Ford Ranger's engine. The dealership is located at 300 West Loop 820 South, Fort Worth, TX 76108.

• Online scheduling is available through the service appointment page.
• Phone: 817-420-7990
• Address: 300 West Loop 820 South, Fort Worth, TX 76108