2016 Ford Taurus Alignment in Fort Worth, TX

Alignment service is generally considered after a major pothole impact, suspension work, or replacement of steering or suspension components. It is also worth checking when the vehicle begins pulling or the steering wheel no longer sits straight. David McDavid Ford can measure the current angles against factory specifications before recommending adjustment.

• Check alignment after a significant road impact.
• Consider measurement after suspension or steering repairs.
• Use tire wear and steering behavior as practical indicators.

A 2016 Ford Taurus may need an alignment check when it drifts to one side on a flat road or the steering wheel is not centered while driving straight. Tires can also scrub against the pavement when wheel angles are out of specification. An inspection helps separate alignment concerns from tire, steering, or suspension wear.

• Vehicle pulls left or right on a level road.
• Steering wheel sits off center when traveling straight.
• One edge of a tire wears faster than the other.

Technicians inspect the tires, steering, and suspension for wear that could prevent the alignment from holding. The process identifies whether adjustment is appropriate before work is performed. Booking service provides current angles measured against the factory specification so you can learn whether an adjustment is needed.

• Camber, caster, and toe measurement on all four wheels.
• Adjustment toward manufacturer specifications where possible.
• Inspection for tire, steering, and suspension wear.

David McDavid Ford inspects steering and suspension components before recommending an adjustment. Loose or worn parts can change wheel angles while driving, so an alignment alone may not correct the underlying concern. The technician can explain the inspection results and identify whether component repair should come first.

• Check tie rods for looseness or wear.
• Inspect ball joints and struts before adjustment.
• Review tire condition for evidence of ongoing scrub.

Measurement is especially useful after a major pothole impact, steering or suspension replacement, or when tire wear changes. A straight-tracking vehicle may still benefit from an inspection if the steering wheel is off center or the tires are wearing unevenly. David McDavid Ford can measure the angles before an adjustment is approved.

• Check alignment after major impact or component replacement.
• Watch for edge wear across the tire tread.
• Confirm steering-wheel position on a level road.

The service includes measurement of camber, caster, and toe, along with inspection of tires, steering, and suspension components. The dealership service department uses Ford-focused equipment and genuine Motorcraft parts when parts are needed. Schedule an appointment online before visiting the West Loop 820 South facility.

• Location: 300 West Loop 820 South, Fort Worth, TX 76108.
• Service includes alignment-angle measurement and component inspection.
• Call 817-420-7990 for service assistance.

Next, technicians measure camber, caster, and toe on all four wheels. Where the suspension allows adjustment, the angles are set back toward the manufacturer's specifications. The work focuses on the actual condition of the 2016 Ford Taurus rather than assuming an adjustment is necessary.

After adjustment, the service record includes the measured results before and after the work, followed by a road test when appropriate. This process helps confirm steering response and tracking. To learn whether your vehicle needs an adjustment, schedule service or call 817-420-7990.

OEM alignment equipment supports precise measurement and helps identify whether an angle is outside specification. The inspection also considers tire wear, steering response, and suspension condition. Uneven tread wear, a vehicle that pulls on a flat road, or an off-center steering wheel may indicate that the angles need to be checked. Worn tie rods, ball joints, or struts can also keep an alignment from holding, so those components should be evaluated before adjustment.

Bring your 2016 Ford Taurus to David McDavid Ford in Fort Worth for a factory-spec alignment — schedule service.

The Service Department provides routine maintenance and more involved mechanical support with OEM-trained mechanics, Ford Master Technicians, specialized equipment, and genuine Motorcraft parts. Alignment service starts with inspection of the tires, steering, and suspension, then measures caster, camber, and toe on all four wheels. Adjustments are made toward factory specifications where the suspension allows.

For directions or appointment help, call 817-420-7990 or schedule service at David McDavid Ford in Fort Worth, TX.