David McDavid Ford

2016 Ford Expedition Oil Filter

Ford Oil Filter service at David McDavid Ford in Fort Worth, TX

Frequently asked questions

Frequently Asked Questions

6 common questions answered

Is the oil filter replaced every time a 2016 Ford Expedition has its oil changed?Yes, the oil filter is replaced with the oil according to the manufacturer’s published maintenance schedule.

The schedule for this model calls for oil filter replacement every 10,000 miles. Replacing both together gives the fresh oil a clean filter to work through instead of sending new oil into a filter already holding debris. The exact service history should also be considered when planning maintenance.

  • New filter matched to the engine
  • Drain plug gasket or washer replaced where applicable
  • Filter seal checked for leaks after the engine runs
What is included in an oil filter replacement on a 2016 Ford Expedition?An oil filter replacement includes an engine-matched filter, a renewed drain plug gasket or washer where used, and a post-service leak check.

The filter is selected for the 3.5-liter V6 engine fitted to the Expedition. After installation and an oil change, the engine is run so the filter seal can be inspected under operating conditions. The service is designed to replace the component that captures debris as part of the oil service.

  • Filter matched to the engine’s specification
  • New drain plug sealing component where the engine uses one
  • Inspection for leaks at the filter seal
What happens if the oil filter on a 2016 Ford Expedition is not replaced?A filter that is not replaced can load with debris and open its bypass valve, allowing unfiltered oil to circulate.

A loaded filter does not stop the engine getting oil; it stops the engine getting filtered oil. Drivers may first notice an oil-pressure warning, an engine that sounds noisier than usual, or oil that darkens quickly after a change. An inspection and the manufacturer’s maintenance schedule help determine the appropriate service.

  • Debris remains trapped in an increasingly loaded filter
  • The bypass valve may allow unfiltered oil flow
  • Warning signs can include noise or an oil-pressure alert
Does a 2016 Ford Expedition need a specific oil filter?Yes, the filter is matched to the Expedition’s 3.5-liter, 3,496 cc six-cylinder V6 engine, and filters are not interchangeable across engines.

The correct filter depends on the engine actually fitted to the vehicle. Matching the filter helps ensure it is appropriate for the engine’s oil system and sealing arrangement without relying on a generic fit. David McDavid Ford can match the filter during the scheduled oil service.

  • Engine: 3.5 liters
  • Displacement: 3,496 cc
  • Configuration: V6, six cylinders
Can the oil be changed on a 2016 Ford Expedition without changing the filter?The oil can be changed separately, but the manufacturer’s schedule calls for replacing the oil filter every 10,000 miles.

Stretching one filter across two oil changes leaves the new oil working through a filter that has already collected debris. Once the filter loads, its bypass valve can allow unfiltered oil to circulate. The vehicle’s maintenance history and the manufacturer’s schedule should guide service decisions.

  • Fresh oil does not clean and renew a loaded filter
  • The filter captures debris carried by engine oil
  • Replacement keeps the oil service and filtration service together
How do I book an oil and filter service at David McDavid Ford in Fort Worth?You can schedule an appointment online or call David McDavid Ford at 817-420-7990.

Share that your vehicle is a 2016 Ford Expedition and request oil and filter service. The service team can match the filter to the 3.5-liter V6 engine, replace the applicable drain plug sealing component, and check the filter seal after the engine runs. You can also review current service offerings before booking.

  • Book online through the service appointment page
  • Call 817-420-7990 for assistance
  • Visit 300 West Loop 820 South, Fort Worth, TX 76108